Windshield wiper blades for Toyota RAV 4 (2013 - present)

Windshield wipers are an important structural element of the vehicle body, which is responsible for the comfort of visibility - if there are streaks or other signs of reduced efficiency, the wipers on the RAV 4 must be replaced. Fortunately, this does not cause any difficulties.

Replacing wiper blades is not the only problem that motorists may have - they also need to choose the right wiper blades. Please be aware that installing an incompatible set of parts may cause the windshield to warp and reduce the driver's and passenger's visibility.

Year of issueGeneration - bodyDriver sidePassenger sideRearMounting type
2015 – presentCA40 Restyling24″ (610 mm)16″ (406 mm)12″ (305 mm)Hook
2012 – 2015CA4024″ (610 mm)16″ (406 mm)12″ (305 mm)Hook
2010 – 2014CA30 Restyling24″ (610 mm)16″ (406 mm)12″ (305 mm)Hook
2005 – 2010CA3024″ (610 mm)19″ (483 mm)12″ (305 mm)Hook
2003 – 2006CA20 Restyling24″ (610 mm)19″ (483 mm)12″ (305 mm)Hook
2000 – 2003CA2024″ (610 mm)19″ (483 mm)12″ (305 mm)Hook

The Toyota RAV 4 body supports most common wipers of compatible sizes, which allows you to install even analogues of original components. The locking system for the front windshield wipers is a “hook” system, while the rear window uses a “hook with an additional hinge” format.

Basic dimensions of wipers on Toyota RAV 4

The size of Rav 4 wipers depends on the year of manufacture of the car and the place where they are fixed. The driver's side windshield wiper is 20-25% longer than the passenger's side. This feature was introduced specifically to improve driving safety. The driver should have maximum visibility of the road situation.

The dimensions of the wipers are different for different generations of the crossover. For models produced from 1994 to 1999, the driver's side wiper length was 20 inches (508 mm). Passenger side - 18 inches (457 mm).

After 2000, the crossover design underwent certain changes. The windshield wiper blades became slightly longer. Toyota RAV 4 manufactured from 2000 to 2004 had a driver's wiper size of 24 inches (610 mm). The windshield wiper for passengers was smaller. Its length was 19 inches (483 mm).

Size of wiper blades Rav 4 2008-2012, 2004-2007. release remained virtually unchanged. The length of the driver's wiper remained the same (610 mm). The dimensions of the windshield wiper installed on the passenger side have been reduced to 406 mm (16 inches).

Size of wiper blades Rav 4 2013-2018 release became different. The company decided to further improve the quality of visibility from the driver. The cleaning elements have become larger: 26 inches. The length of the passenger windshield wiper remained the same (406 mm).

The 5th generation Toyota Rav 4 wipers have not undergone any changes.

Good producers

Glass cleaners for Rav 4 crossovers are supplied to the market by both Russian and foreign manufacturers. The choice of windshield wiper blades is wide, but it is better to buy products from well-known companies: Bosch, Trico, Valeo, Denso and Champion.

Bosch products are reliable and durable. The manufacturer has established itself as the creator of a high-quality and high-tech product, and automotive consumables are not the only segment of the group of companies’ activities.

Trico is a company with history that began producing windshield wipers at the beginning of the last century. Today the brand is considered one of the best car accessories on the market.

Valeo is a concern that supplies components for automobiles to the largest automakers. Valeo wipers are reliable and constantly improved.

The Japanese manufacturer Denso is working on the creation of automotive components; the production of windshield wipers is one of the company’s directions. As a supplier of automotive consumables, Denso ranks second in the global ranking.


Denso has been a long-time supplier of brushes for Toyota.

The American brand Champion focuses on the production of spare parts. The product range has recently been expanded to include windshield wipers for cars and trucks.

Wipers for Toyota Rav 4 are supplied by all of these companies. Which one to choose, everyone decides for himself.

Types of wiper mounts

There are several options for fixing windshield wipers, each of which has its own advantages and disadvantages:

  • side pin;
  • button;
  • narrow button;
  • side mount;
  • side clamp;
  • top lock;
  • bayonet lock;
  • claw.

Rav 4 windshield wiper blades use a “hook” mount. It is considered a classic.

Until 1999, the method was used on all cars without exception. However, then Ford decided to change the system and began installing different types of mounts on the windshield wipers. Other manufacturers followed the example of the North American concern. But Japanese companies still use the “hook”.

Most often, the mount has standard dimensions of 9 by 4 or 9 by 3. Very rarely, other parameters are found: 8 by 3 (can be used for a passenger wiper).

The “side pin” method of fixing windshield wipers is popular among German concerns. It began to be used in 2005. This mount is used on Audi, Mercedes-Benz, VW, BMW models.

Sometimes the "side pin" is used in Volvo and Peugeot cars. The length of the fixing element is 22 mm. The 17 mm mount appeared in 2009 on some BMW vehicles.

The “button” is common on cars from European manufacturers. It is used in VW, Citroen, Volvo, Renault. The mount is square with a side of 19 mm.

Since 2010, they began to use a “narrow button”. The side length of the square retainer has been reduced to 16mm. It was installed on VAG cars.

Side mounting is common in Renault cars. Other automakers use it much less frequently.

The popularity of the “side clamp” fixation method is comparable to the classic “hook”. Wipers are “clamped to the side” on cars of the brands Saab, Audi, Opel, Fiat, Mercedes-Benz.

The "top lock" is very similar in appearance to the "side clamp". However, the fixation method is different. This type of installation is used on BMW 5 and 6 series cars.

Owners of Renault and Saab cars know about the “bayonet lock” method of fixing windshield wipers. Fastening began to be used after 2004. Trucks use a similar method. But the design of their wipers has two holes.

“Claw” is less common than the others. It is used only on modern versions of the Audi A6. No one else uses this method of fixation.

Frameless windshield wipers for Toyota Rav 4

The new Toyota Rav 4 wipers have a hybrid design. Drivers sometimes install frameless analogues instead. Such interchangeability is quite justified. In terms of their cleaning abilities and reliability of operation in winter, the models are approximately the same.

The frameless wiper body is shaped like a spoiler. Two metal plates are inserted inside, between which there is a rubber seal. Its edge cleans the windshield. The mounting bracket is located in the center.

There are no wearable hinges in the design. The spoiler shape increases downforce. The brushes effectively remove water and dirt even at speeds of 120-150 km/h.

Frameless brushes do an excellent job of removing icing. During operation, they do not warp and do not create additional noise. If the windshield wipers are physically worn out, drivers can only change the rubber band itself. To replace the edge, you need to remove the end caps, after which the gasket can be easily removed.

Changing wipers on Toyota Rav 4 3

How to change worn windshield wiper blades? On the third generation Rav 4 crossover, windshield wipers are replaced in the following order:

  1. The latch holding the brush is pulled up . To do this, it is better to use a screwdriver to avoid damaging your nails.
  2. The leash is raised, the wiper is retracted.
  3. The brush carefully removed . You need to release the leash smoothly, because if you pull back sharply, it can break the windshield.
  4. The new brush is removed from the packaging and replaced with the old one . The latch snaps into place .
  5. The procedure is repeated with the second wiper.


The Rav 4 has a hook type of attachment.

Original wipers Rav 4 3 can be ordered online. The part number for the passenger side wiper is 85212-42120. Its length is 405 mm. The article number for purchasing consumables on the driver’s side is 85222-42110. Its size is larger - 610 mm.

Frame

These types of wipers appeared first. They are still common today. However, many automakers are gradually abandoning them. An elastic band with a cleaning edge is fixed on a massive metal frame.

The only advantage of such systems is the price. Frame brushes are cheaper than others. They are made of metal or plastic. Polymer models resist icing better. They clean glass well and last longer.

Metal frame windshield wipers quickly become loose and become unusable. Their service life does not exceed 12 months. Then streaks appear on the glass, indicating the need to replace the element.

The downforce on frame wipers is minimal. At speeds of 120 km/h and above, the quality of their work will steadily decline. The edges of the cleaning eraser may completely move away from the surface of the glass. Sometimes, to increase aerodynamics, manufacturers attach small spoilers to the frame.

Replacement

Installing a new set of windshield wipers on the latest generation RAV 4 will not cause any particular difficulties even if you do not have practical skills in servicing the car - the entire process is carried out according to an intuitive scenario and takes no more than 20 minutes. To replace the windshield wipers, you will need a slotted screwdriver or pliers, as well as a piece of foam rubber or a small cloth for cushioning. Replacement occurs as follows:

  • To begin, move the metal frame of the windshield wipers away from the windshield and place a small soft cloth: a towel, foam rubber or rags for wiping. The fact is that the degree of pressing to the surface of the windshield is determined by a mechanism with a spring, which can work when servicing the windshield wipers and deform the glass;
  • Next, using a screwdriver or pliers, unclip the latch that secures the wiper blade to the frame and pull out the worn part by moving it upwards and towards you. The “hook” type fastening itself is located on the back side of the windshield wipers at the bottom of the blade;
  • Then we carefully lubricate the frame seats with technical lubricant, which will prevent metal corrosion, and install new brushes, after which we fix the new elements. We repeat a similar procedure with the second wiper.

The rear wiper is changed in the same way, but the clips are removed from the inside of the trunk door after first releasing the decorative plug.

Hybrid wipers

Original Toyota Rav 4 hybrid wiper blades. The frame is small in size and covered with a casing. The fairing retains the shape of an aerodynamic wing. Even the edges of the wipers are pressed against the windshield with great force.

The frame is hinged. It increases the tightness of the cleaning edge to the surface. Hybrid wipers perfectly clean glass with different convexities. Divorces are excluded.

The disadvantage of hybrid windshield wipers is their high price. These models are more expensive than others. The cleaning edge is made of natural rubber. It can withstand even intense friction.

The advantages of hybrid wipers include good cleaning ability, minimal risk of icing in winter and a long service life. These windshield wipers last for 3-4 years of operation.

CA40

The latest generation of Toyota RAV 4 is the CA40 generation, which is characterized by changes in the structural features of the body and power unit. Windshield wipers for the latest version of RAV 4 are identical to the previous generation, and are also completely interchangeable with the restyling and pre-restyling versions.

Original articles

A genuine set of windshield wipers is the best option for replacement, as it fully takes into account the structural features of the vehicle body. The average cost of stock wipers varies between 800-1300 rubles per set, official articles - 3397010297, 3397013434, 3397010RR.

Replacement options

Analogues of original components are often purchased in order to save on vehicle maintenance - often such parts have a level of quality that is not inferior to the original ones, but have a lower cost, which is characterized by the absence of overpayment for the brand.

The most popular alternative windshield wipers are the following models:

Manufacturervendor codeCountry of OriginStructural arrangementApproximate cost, rub.
Bosch Aerotwin119860BelgiumFront glass1480
Bosch Twin Spoiler119843BelgiumFront glass1650
Bosch Eco3397118907BelgiumFront glass1460
Bosch Rear3397118343BelgiumRear glass1560
SWF VisioNext567940EnglandRear glass1450
Valeo Silencio567947FranceFront glass1780
X-TRM AftermarketDUR-060LFranceFront glass1980

Note! If you purchase a non-original set of windshield wipers, it is important to check the parts for compatibility with the vehicle’s VIN code on the manufacturer’s official website.

Frame

Frame wipers are a two-component structure consisting of a metal frame and a removable brush. Characterized by low cost and low maintenance. A popular model for RAV 4 is SWF VisioNext, article number 119860.

Frameless

The main feature of frameless wipers is their aerodynamic design, which ensures low noise levels and tight fit. A popular model is Valeo Silencio, article number 567947.

Hybrid

The design of hybrid windshield wipers combines all the advantages of frame and frameless types - wipers are characterized by high efficiency and a long service life, but have a high cost on the market. The most popular options for Toyota RAV 4 are Trico Hybrid, part numbers hf480 and hf485.

Winter

A specialized type of windshield wipers designed for use in cold weather. Resistant to temperature changes and prevents the risk of glass deformation if there is a crust of ice on its surface. The Bosch “AR601S” is considered a proven option.

Rating
( 1 rating, average 4 out of 5 )
Did you like the article? Share with friends:
For any suggestions regarding the site: [email protected]
Для любых предложений по сайту: [email protected]